First piece inspection
First piece inspection is the check of the first part made after a setup, tool change or shift start, so errors are found before the batch is run.
What it means
After a setup or tool change, a machine can drift off size. The operator makes one piece, measures the key dimensions and has the inspector approve it before the run continues. A wrong setting caught at piece one costs one piece; caught at the end it can cost the whole lot. It is routine at each setup, unlike first article inspection, a formal check for new parts.
Example
A turning shop sets up a lathe for 1,000 shafts. The first shaft is 0.05 mm over on the bearing diameter, so the operator adjusts the offset, gets approval and runs the batch, avoiding about ₹45,000 of rejected shafts.
Records and checks
- Record the part, machine, operator, date, readings of key dimensions and the approver's initials.
- Verify the instruments used are within their calibration period.
- The line inspector or supervisor approves the piece before the operator proceeds.
Common mistakes
- Letting the operator approve their own piece when an independent check is required.
- Skipping the check after a mid-shift tool change because the setup was approved earlier.
Did not find your answer?Message the lamp team on WhatsApp. Ask about setup, your records, or anything we have not covered here.Ask us on WhatsApp →