Non-conformance
A non-conformance is a failure to meet a specified requirement, whether in a product, a process step or a record.
What it means
The requirement may come from a drawing, a customer order, a standard or the firm's own procedure. A part outside tolerance is a non-conformance, and so is a calibration that was due and not done, or a record that is missing. Naming it triggers a defined response: contain, dispose of the goods, find the cause.
Example
During a stage check at a fastener plant, the inspector finds 300 bolts with thread length 2 mm short of the drawing. The lot is tagged and moved to a hold area, the supervisor is informed, and a decision is taken to rework 280 and scrap 20 that are beyond recovery.
Records and checks
- Record what was found, where, the quantity, the requirement it violated and the date.
- Verify that the affected stock is physically segregated and labelled.
- The inspector raises it, and the quality head decides its disposal.
Common mistakes
- Quietly reworking parts without noting them, so repeat problems never show in the data.
- Treating non-conformances in records or procedures as less serious than product defects.
Did not find your answer?Message the lamp team on WhatsApp. Ask about setup, your records, or anything we have not covered here.Ask us on WhatsApp →