lamp.
ResourcesPricingAbout

Turning

Turning is a machining process in which a single-point cutting tool removes material from a rotating workpiece to make cylindrical shapes, steps, tapers and threads.

What it means

It is done on a centre lathe or a CNC lathe, and the part is held in a chuck or between centres. Operations include facing, plain turning, grooving, boring and threading. Finish depends on speed, feed and tool nose radius.

Example

A shop turns 400 shafts from 25 mm round bar down to 22.00 mm, with a shoulder and a thread at one end. Each takes 3 minutes on a CNC lathe, and the operator measures the diameter every ten pieces to catch tool wear.

Records and checks

  • Record the material, bar size, program revision, tooling, speed, feed and cycle time per piece.
  • Verify the first piece fully and sample critical diameters during the run.
  • The operator measures along the run, and the inspector approves the first piece and final lot.

Common mistakes

  • Letting the tool wear without adjusting the offset, so diameters creep out of tolerance.
  • Gripping a long thin bar with no tailstock support, which causes chatter and taper.
Did not find your answer?Message the lamp team on WhatsApp. Ask about setup, your records, or anything we have not covered here.Ask us on WhatsApp →