Cutting allowance
Cutting allowance is the extra length or width of material added to a part's finished size to cover the cut width, end trimming and finishing, so the part reaches its size.
What it means
When you cut a bar or sheet, the saw or torch removes some material, and the cut ends are often rough or uneven. A cutting allowance covers this loss. The amount depends on the cutting method and the material.
Example
A fabricator needs 40 pieces of 500 mm length from 25 mm round bar using a hacksaw. With a 3 mm allowance per cut for blade width and facing, each piece is cut at 503 mm, and a 6-metre bar gives 11 pieces.
Records and checks
- Record the part length, allowance used, cutting method and the number of pieces yielded per stock length.
- Verify the first cut piece with a tape or caliper and check that the allowance is consistent across lots.
- The cutting operator measures, and the planner uses the same allowance when working out material needed.
Common mistakes
- Forgetting the allowance in the material estimate, so the shop runs out of stock before the order is complete.
- Adding the same allowance for laser cutting and band saw cutting, which waste different amounts.
Did not find your answer?Message the lamp team on WhatsApp. Ask about setup, your records, or anything we have not covered here.Ask us on WhatsApp →