lamp.
ResourcesPricingAbout

Plastic scrap

Plastic scrap is waste plastic produced in processing, including rejected parts, runners, purge, start-up material and trimmings, which may be reground and reused or sold.

What it means

Every moulding or extrusion run produces some scrap. Clean runners and trimmings of a known grade can often be ground and mixed back, within limits. Rejected parts with contaminants, mixed grades or colour problems may not be reusable and are sold as low-value scrap. Because resin is the largest cost, scrap rate is a major control figure and should be tracked by cause.

Example

A moulder uses 10,000 kg of resin in a month. Scrap is 650 kg, a rate of 6.5 percent. Of this, 400 kg is clean runner that is reground and reused, 150 kg is start-up purge that is sold and 100 kg is rejected parts with black specks, which is traced to a dirty hopper.

Records and checks

  • Record scrap weight by cause, material grade, machine and shift, and whether it was reused or sold.
  • Verify that material issued equals good parts plus scrap plus the stock movement, so nothing is unaccounted for.
  • The operator weighs and logs, the stores in-charge reconciles monthly, and the owner reviews the causes of the largest items.

Common mistakes

  • Mixing different grades or colours of scrap in one bin, so none of it can be reused.
  • Not weighing scrap, and so never seeing how much resin is lost.
Did not find your answer?Message the lamp team on WhatsApp. Ask about setup, your records, or anything we have not covered here.Ask us on WhatsApp →