lamp.
ResourcesPricingAbout

Tonnage

Tonnage is the rated clamp force of a moulding or press machine, stated in tonnes, indicating the largest job it can hold shut under pressure.

What it means

Machines are sold by tonnage, such as a 90-tonne or 250-tonne injection machine. A rough rule is that the clamp force needed rises with the projected area of the part and the cavity pressure, so bigger or more cavities need more tonnage. A machine too small flashes, while one far too large wastes power and is costly to run. Tonnage is one of several checks, alongside shot size and mould space.

Example

A moulder has a new mould whose parts and runners project over about 400 cm2 and need around 90 tonnes of clamp force. The shop has a 100-tonne and a 250-tonne machine. The planner picks the 100-tonne, which has enough force and costs far less per hour than the 250.

Records and checks

  • Record each machine's rated tonnage, the force needed by each mould and the machine it runs on.
  • Verify, before booking a job, that the mould fits the platen and that tonnage and shot size are within the machine's limits.
  • The planner proposes the machine, the setter confirms during setup, and the supervisor reviews any job near the limit.

Common mistakes

  • Running a mould near the machine's maximum, which strains the tie bars and the mould.
  • Choosing the biggest machine for every job, which raises cost per hour for no gain.
Did not find your answer?Message the lamp team on WhatsApp. Ask about setup, your records, or anything we have not covered here.Ask us on WhatsApp →