lamp.
ResourcesPricingAbout

Extrusion

Extrusion is a process in which melted plastic is pushed through a shaped die to form a continuous product such as film, pipe, sheet or a profile.

What it means

Resin pellets feed into a heated barrel with a rotating screw that melts, mixes and pushes the plastic through a die. The shape of the die decides the product: a ring for a pipe or a blown film, a slot for a sheet. The product then passes through cooling, is pulled at a controlled speed and is cut or wound. Output is measured in kilograms per hour or metres per minute.

Example

A pipe unit extrudes 20 mm PVC conduit at 18 metres a minute. The die gives the wall thickness, the cooling bath sets the shape and the puller controls the speed. Each hour the operator checks the outside diameter and wall thickness with a gauge and cuts a sample length for a weight check.

Records and checks

  • Record the material grade, barrel zone temperatures, screw speed, line speed, output rate and the dimensions measured.
  • Verify the dimensions, weight per metre and surface finish at fixed intervals during the run.
  • The operator logs the readings, the quality inspector verifies the samples, and the supervisor reviews downtime and scrap.

Common mistakes

  • Changing the line speed without changing the cooling, so the product comes out out of shape.
  • Restarting after a stop without purging, and getting black specks in the product.
Did not find your answer?Message the lamp team on WhatsApp. Ask about setup, your records, or anything we have not covered here.Ask us on WhatsApp →