Work at height
Work at height is any task carried out where a person could fall from one level to a lower one and be injured, including roofs, ladders, scaffolds and open edges.
What it means
Falls are a leading cause of serious injury in factories and construction. The usual order of control is to avoid the work, then use a safe platform with guardrails, then use fall arrest such as harnesses, and last use ladders for short light tasks.
Example
A warehouse in Bhiwandi needs a roof sheet replaced at 9 metres. The owner hires a crew with a scissor lift at ₹7,000 per day and a permit rather than letting staff climb a ladder, and a spotter is posted below.
Records and checks
- Record a work permit with location, height, equipment, crew names and permit time.
- Verify scaffolds, harnesses and anchor points are inspected and tagged before use.
- The safety officer issues the permit and checks the setup before the crew goes up.
Common mistakes
- Using a harness without a secure anchor point, so it gives no protection.
- Treating a quick job on a ladder as too small to need a permit or inspection.
Check the current rule on the official portal or with your CA before acting.
Did not find your answer?Message the lamp team on WhatsApp. Ask about setup, your records, or anything we have not covered here.Ask us on WhatsApp →